37201 Head Interface HIF: Timeout waiting for the write laser The commands implemented by the exposure head are non-blocking. As a result, the command to configure the write laser control mode will only initiate the write laser control mode. This error code indicates a timeout waiting for the configuration of the write laser control mode. Note that this error code indicates that the exposure head has not responded. Since the exposure head specifies the timeout, this error will typically indicate a firmware development error on the exposure head. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Fault error in firmware. 30-Jul-2002 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:08 2008 PST